The Paddock Divider Kit

Permits separated containment of animals within a single Port-A-Paddock

The Divider Kit is packaged as a single strand.  To the left, one kit is installed as a single-strand divider.  To the right, two kits are used to accomplish a double-strand divider.

Note the jumper wire (in this case red) that comes with each Divider Kit to connect the Kit to the perimeter wires electrically.

When installing the perimeter line posts onto which the Divider Kit will attach, they should be stepped in on a steep angle.  When the Divider Kit wire is then attached, it will pull that post back upright, maintaining a clean appearance and tension on the Divider.

LEFT:  A non- conductive handle is at the end of each Divider Kit wire, providing for the gate opening to access the "inside" half of the paddock.

RIGHT:  A plastic slider on each Divider strand takes up the slack, permitting the Divider to adjust to whatever width the paddock ends up being each time it's set up.